Elinchrom 19350 User Manual download pdf (Page 11)

Troubleshooting

Should an error occur, rst check the following points:

Having this problem? Check the following points:

No ash unit can be triggered

with the Transmitter

Mode “All” is selected

 Check if the Transmitter is switched ON.

 Check battery polarity.

 Check if the Receiver module is connected correctly to the unit.

 Check if the frequency selector switch is set to the same channel.

 Check if Transmitter is in the same trigger mode Speed or

Standard.

Some units do not re when

triggered with the Transmitter

Mode “Grp” is selected

 Check if the Channel selector switch is set to the same Group.

 Reduce distance to any “not working” unit.

 Check if Transmitter is in the same trigger mode Speed / Standard.

TEST ash works, but the

camera will not trigger ash

unit

 Check hot-shoe tting.

 Connect the 2.5 mm to PC SYNC cable instead of hot-shoe

connection.

Limited Distance range

 Reposition the units.

 Increase the distance to walls and ceilings.

 Position the antenna of Transmitter and Receiver.

 Use an RX extension cable to reduce the distance between the

modules.

CE Statements

This device has been tested and found to comply with the requirements set

up in the council directive on the approximation of the law of member states

relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and

R&TTE Directive 99/5/EC

1 2 ... 6 7 8 9 10 11 12

No comments

Elinchrom 19350 User Manual Page 11