Elinchrom D-Lite 4 it Service Manual download pdf (Page 10)

Sychronisation socket

Open ﬂash «test»

The standard photocell can be remotely triggered by another ﬂash unit!

The D-Lite RX 2/4 photocell is specially designed to work in studio light conditions

Direct light or other strong light sources may reduce the sensitivity of the cell.

Eye-Cell – advanced photocell sensor

Having pressed the touch pad to release a ﬂash, the green «READY» light

will appear again once the unit is recharged. If the green light does not

appear the charge system could be defective.

Please contact an authorized Elinchrom service centre.

Test and Ready (4)

Sync

Standard socket with 3.5 mm mini-jack (5).

N.B. Do not link ELINCHROM units by cable to other manufacturers sync. outlets.

ELINCHROM uses low voltage (5 V) for security reasons.

The ﬂash / modelling lamp power is displayed in f-stop compatible formats from 2.0 - 6.0 for

D-Lite RX 2/4

. The ﬂash power difference from (e.g.) 5.0 – 6.0 is 1f-stop.

The power range is 5 f-stops, variable in 1/10th intervals. During charging or discharging, the

display «ﬂashes». In case of overheating or malfunction, the display shows “E” for error followed

by the error code number.

Display 2.0 3.0 4.0 5.0 6.0

Joules / Ws 25 50 100 200 400

Note: The «D-Lite RX 2/4» units have an integrated discharge system, protected by a thermal

switch. To avoid overheating, discharge manually with the «test» button if you want to

decrease the power for more than 2f-stops.

Digital multi-display English

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 130 131

No comments

Elinchrom D-Lite 4 it Service Manual Page 10